It was not easy, but it should work.
There will be a 3.5" coupler where the blue tape is to connect the end tank out let to the throttle body.
Here a few shots with it out of the car, I used the same method as the runner entry on the SMIM to blend the end tank into the throttle body. Also I will be welding a short piece of 3.5" pipe to the inlet end tank and attach it to the turbo with a 3"-3.5" transition coupler.
Here is the bottom, just a little more welding to do, then make new mounts for it.
welded inside and out to make sure it holds up to the 50+ psi it should be running.
I was in Florida last week, but its getting closer to engine dyno time.
~John