I get it now, the inner race that is on the hub is part of the entire wheel bearing and the other half of it is still pressed into the knuckle. Maybe if I had a new wheel bearing infront of me I would have realized that. Thanks for setting the noob straight! Does the knuckle dust seal have to be pressed out? And the chilton's says to remove the snap ring from the axel side of the knuckle, is it under the dust seal?
This is waist deep at Vail, my favorite place in colorado. I've never been in anything like it besides 3 feet a steamboat crawling through the snow in the flats cuz steam boat is flat everywhere.
Cliffs at vail
I'm proud to say I will be a colorado resident again this winter working at keystone! I can get some more waist deep pow before it's all gone due to global warming
