Quote:
Originally Posted by slowboy101
Ok this is the deal I have my transmission taken apart to swap bellhousings, but ounce apart I found out I had to replace bearings and a couple other things well when I went to put it together it wouldnt go together right so I took it apart again to double check every thing and every thing was all good so I put it back together ounce again and the middle casing wasnt sitting flat so this is my offer if you can come over and get it together and working I will hand you a 100 dollars.
|
Make sure the bearing races are not sitting crooked in the mid housing for the gear set.
Did you pull apart the gears? Are the gear sets sitting flat/flush on the bellhousing case?
Shift forks installed correctly? Do you have the detent balls still in the end case? If those are in there still, the shift rails could be binding up and not letting you button it together.
If you weren't in Lakeville I would come fix it for the $100, lol.