MitsuStyle - View Single Post - Introducing MAP Custom O2 Sensor Housings!

niterydr · 03-05-2009

That part looks familar in design to one I remember seeing construted 5 years ago

. It was a great design then, and a great one now. There are only so many ways to make a 02 housing on a dsm! I am assuming that is for a tial 38mm, does it clear the PS pump on a dsm? I know of one that didn't quite clear well, this one looks good.

Looks very good guys, I'd recommend grinding off the vibrant name on the flange, otherwise they look like a Vibrant 02 housing, not a MAP 02 housing.

03-05-2009	#5
niterydr back in the saddle again 24 Hours Rally Champion! 3D Pacman white house edition Champion! 3D Racing - Track 2 Champion! ATV Winter Challenge Champion! Bloody Pingu Champion! WRX Racing 2 Champion! Tournaments Won: 5 Join Date: Oct 2003 Location: Elkhart Texas Drives: 2015 Ram Quad Cab Hemi, 1999 FRC Corvette, 93 Stealth Turbo Posts: 6,411	Re: Introducing MAP Custom O2 Sensor Housings! That part looks familar in design to one I remember seeing construted 5 years ago . It was a great design then, and a great one now. There are only so many ways to make a 02 housing on a dsm! I am assuming that is for a tial 38mm, does it clear the PS pump on a dsm? I know of one that didn't quite clear well, this one looks good. Looks very good guys, I'd recommend grinding off the vibrant name on the flange, otherwise they look like a Vibrant 02 housing, not a MAP 02 housing. __________________ My street car runs low 11's and my race car's personal best is a mid 11.... Last edited by niterydr; 03-05-2009 at 07:42 AM..