[turbotalon1g]

I want to put an electric cutout on my car. I have a Buschur 3" downpipe and test pipe, then stock catback bolted on to the back of that.

I love it dead quiet for cruising around, car goes by cops unnoticed (kinda its a panda car).

Of course I don't want to lose performance so I bought a cutout, anywho I was wondering what is the best way to put it into the exhaust system.

I found a cutout pipe/flowtech at a local shop and it was basically a rectangle patch cutout on the straight pipe to suck flow from the normal route. My thought was that the exhaust would still want to go straight back or will it take the easier route of going out of the cutout?

I thought of cutting a hole in the test pipe and intersecting/block a lot of the flow with the cutout then I will for sure be getting most of the flow thru the cutout when it is open.

Thanks for your time and comments. I just want to do this the right way.

Aaron