[Febo]

I can confirm this. Your gunna need:

Trans
Cables
Cable brackets and C clips
Firewall Cable rubber grommet thingy
Shifter Assy
Pedal Assy, make sure its out of an AWD, I noticed there is a difference in pedal assy's
Master Cylnder, 1.8l one will work. I have one that needs a rebuild, shoot offer
Clutch line
Abs bracket with hole if you have abs
Rubber hose from hard line to slave cylinder
Slave cylinder
Clutch
Flywheel
Transfer
Rear Diff
Manual ECU

Then make sure to connect the two black wires on your 12 pin tranny connector
You will also need a small spring to permanantly keep your key in the unlock position. Or you will need a manual ignition.

You will also need to retain your original stop light switch, and find the wiring diagram to make your reverse lights work. I havent gotten that far yet. Its annoying.

I think thats everything that you will need. So plan accordingly.