MitsuStyle - View Single Post

hippiekiller · 01-18-2008

Well I found a deal and half on some Recaro's out of an Evo, so I picked them up. Going to get the centers re-upholstered in black suede.

Also picked up a new engine for it. No pics at the current moment though.

But it has

Eagle H beam rods
Wiseco pistons bored .020 over and a 8.5 compression ratio
Butcher Crank from FFWD

Should be a good little engine for me. Also picked up HKS 272's from the same guy. So basically my hole engine set up will be new and I am also picking up a new turbo as well. It will be a whole new car when it finally warms up outside and I can start working on it again.

01-18-2008	#3
hippiekiller Join Date: Aug 2007 Location: Hudson Posts: 390	Re: My restoration of a 2g GSX Well I found a deal and half on some Recaro's out of an Evo, so I picked them up. Going to get the centers re-upholstered in black suede. Also picked up a new engine for it. No pics at the current moment though. But it has Eagle H beam rods Wiseco pistons bored .020 over and a 8.5 compression ratio Butcher Crank from FFWD Should be a good little engine for me. Also picked up HKS 272's from the same guy. So basically my hole engine set up will be new and I am also picking up a new turbo as well. It will be a whole new car when it finally warms up outside and I can start working on it again.