[Pushit2.0]

In the bar screen you hit the X key on the keyboard and there is a correction factor you can type in. Normaly this is 1.000 but you can take power away or add as much as 3.000. This will change the power and torque reading in the bar screen and the graph screen. Or if you load up a graph from any car you can add or take power away. If the dyno run was done with the correction in place it would show up in the Snap shot file. If you type in 1.130 if would add 13% HP and Trq in the graph screen and the bar screen. The way Dyno Dynamics intended people to display more power then the car was making was with Shoot out mode, this would give a more "real world" number.

~John