MitsuStyle - View Single Post

**asshanson** · 12-12-2007

Worked on it quite a bit today, and everything was going slow as usual so I didn't get done everything I wanted to.

However, the front wheel assemblies are all put together except for the center nut thingy, which is like 30mm and I don't have a socket that big, but I should have one tomorrow.

Also, I spent like an hour dealing with these stupid studs on the intake mani. They are an inch longer than the usual length and it took FOREVER to get them off. It took three nuts together as tight as I could, and a couple tries with that to get them broken loose. These are the stupid little problems I've been dealing with the entire process.

12-12-2007	#74
asshanson immune from paybans Join Date: Oct 2005 Location: West Des Moines Drives: poorly Posts: 4,358	Re: Make slowboy not so slow Worked on it quite a bit today, and everything was going slow as usual so I didn't get done everything I wanted to. However, the front wheel assemblies are all put together except for the center nut thingy, which is like 30mm and I don't have a socket that big, but I should have one tomorrow. Also, I spent like an hour dealing with these stupid studs on the intake mani. They are an inch longer than the usual length and it took FOREVER to get them off. It took three nuts together as tight as I could, and a couple tries with that to get them broken loose. These are the stupid little problems I've been dealing with the entire process.