I was building this car to run 8s at some point. It would only take a few weekends of work to finish this car. The body is in fare shape a little rust around the window, a few dings here and there. The interior is stripped right now, and has a 8point roll cage in it(would be certified for an 8.50@150mph. I have the full interior and a lot of extras. I also did not plan on running any kind of lights, head lights or tail lights so you would need to wire those back in, this was going to be a series race car. The chassis has just over 100k on it and here is the VIN: JA3CX56U0MZ010883 and I would also part the car out if that would work better. Here is the link to the gallery with most of the pics:
http://lseperformance.com/gallery/ma...g2_itemId=3231
I will get a few more pics up of the rest of the car tonight.
Here is the new list of for sale items.
LSE stage 4 short block (2.0L still), 40 over 9.25:1 Weisco pistons, Crower rods, ARP mains, LSE main cap pins, no oil squirters, new TB side w/ Greddy timing belt
-LSE stage 6 head, race port head, 2mm over I/E SS valves, Crower 415s, Crower cam gearsn
-Cometic HP head gasket
-A1 L-19 head studs
Running engine $5000 obo
-ACT street light flywheel $120 obo
-Custom south bend race only clutch (single disk design) $300 obo
-3bolt ring/pinion 4bolt rear end combo $250 obo
-water to air IC setup, with a custom side mount heat exchanger, intake air temp was only 10deg above outside air temp at 47psi..... with no ice in the water tank. $650 obo
-AEM EMS for tuning, AEM 5bar MAP, GM AIT sensor, 93 CAS (pending sale)
-Full MSD ignition, DIS 2, GM twin post coils, MSD wires $450 obo
http://img443.imageshack.us/my.php?i...sc02371it9.jpg
http://img443.imageshack.us/my.php?i...sc02370uq8.jpg
http://img443.imageshack.us/img443/5...2369bk9.th.jpg
The hole car as it sits: $7,000 OBO
I just do not have the budget to finish and maintain the car, I wish I did, but not right now. Email:
GalantVR41062@yahoo.com, PM, Phone:7634254340. Thanks for looking!
~John