View Single Post
Old 07-15-2007   #11
xveganxcowboyx
Wanker
 
xveganxcowboyx's Avatar
 

Join Date: Nov 2005
Location: St Paul, MN
Drives: 95 M3
Posts: 1,027
Re: Advice about bad bearing, rod, and crank

Unfortunately due to work I will not have any large amount of spare time for, oh say, 4 years... All of that starts in about a month. That's why i was in a bit of a hurry. Now that I pulled the head I might just end up waiting longer and build it better. I was expecting the head at least to be in reasonable condition since it was supposedly rebuilt, but obviously it was not. I can see light through half the valves when I shine a flashlight through. Pictures of all this fun coming in a few minutes.

And yes, it's a spare block. Mine runs fine, but has had low compression for a while. In theory I can wait but I wish I didn't have to.










Last edited by xveganxcowboyx; 07-15-2007 at 01:57 PM.. Reason: Pics
xveganxcowboyx is offline   Reply With Quote