MitsuStyle - View Single Post

MATCHBX · 06-02-2007

I'd go $175 on mine. It has everything in it and ready to go. One exhaust stud broke off inside of it, but a machine shop could get it out cheap. Otherwise it was decked, 3 angle valve job done, valve guides knurled, new valve stem seals, cleaned and it was checked for cracks. Has about 5000 or so miles on it since this was done. I pulled it off of my old engine before I threw a complete 6-bolt in the car. It hasn't been used since. It is a 6-bolt head off of a 91 GSX. It was on a 93 7-bolt block before the balance shaft bearing went out in the engine. Caused no damage to the head. Pics can be found in this thread.

http://www.dsmstyle.com/forums/showthread.php?t=15091

06-02-2007	#7
MATCHBX Any 2 card caller. Pinball Smash Up Champion! Join Date: Oct 2003 Location: Just ahead of the dust Posts: 1,569	Re: WTB 1g HEAD I'd go $175 on mine. It has everything in it and ready to go. One exhaust stud broke off inside of it, but a machine shop could get it out cheap. Otherwise it was decked, 3 angle valve job done, valve guides knurled, new valve stem seals, cleaned and it was checked for cracks. Has about 5000 or so miles on it since this was done. I pulled it off of my old engine before I threw a complete 6-bolt in the car. It hasn't been used since. It is a 6-bolt head off of a 91 GSX. It was on a 93 7-bolt block before the balance shaft bearing went out in the engine. Caused no damage to the head. Pics can be found in this thread. http://www.dsmstyle.com/forums/showthread.php?t=15091 __________________ "I'll believe that when me shit turns purple and smells like rainbow sherbet." Some days you're the dog, some days you're the hydrant. It's always the second mouse that gets the cheese.... I reject your reality and substitute my own. Superjealousfragilemisswithsexualneurosis----John Valby Last edited by MATCHBX; 06-02-2007 at 02:03 PM..