MitsuStyle - View Single Post - Shitty ordering luck or what? Aluglide vs. Duraglide

Onefast99gsx · 05-23-2007

Well I put the bearings on the rods tonight. One of the bearings in the package was pressed into another one. Almost as if a bearing was pressed into a rod cap. Had a heck of a time pulling them apart. When I pulled them apart, I noticed a small scratch. It's not very deep at all. You can just barely feel it with your finger nail. I went directly over it a few swipes with some 800 grit and then cleaned with brake cleaner.

I'll attach some pictures. Does anyone think this is ok to run?

Thanks.

05-23-2007	#4
Onefast99gsx Join Date: Sep 2004 Location: Wisconsin Posts: 1,411	Re: Shitty ordering luck or what? Aluglide vs. Duraglide Well I put the bearings on the rods tonight. One of the bearings in the package was pressed into another one. Almost as if a bearing was pressed into a rod cap. Had a heck of a time pulling them apart. When I pulled them apart, I noticed a small scratch. It's not very deep at all. You can just barely feel it with your finger nail. I went directly over it a few swipes with some 800 grit and then cleaned with brake cleaner. I'll attach some pictures. Does anyone think this is ok to run? Thanks. Attached Thumbnails