MitsuStyle - View Single Post

**scheides** · 02-20-2007

Buschur Racing "Street" core/2G FMIC Kit. Measures 11x24x3.5" and was tested at <1psi pressure drop. I had this on my GSX w/ a bastard20G turbo. The car made 300whp (dyno dynamics) at 28psi and after 4 pulls the core was so hot it could cook meat on one end and cold on the other. Very efficient core, nice size as it seems to fit in a lot of places. Installation on my 2G required a lot of trimming, but I would buy it again as it comes with a nice set of all the piping needed.

I have this same core w/ different end tanks on my Evo, it is sold as the 'Deluxe' FMIC. Stock turbo w/cams it made 294whp @22.5psi (peak) on 92 and again, the core gets a little hot on one end but after about 4 inches it is cool to the touch. Best part was installation. I did have to trim two teeny tiny clips that hold on the very outside upper corners of the mesh in the stock bumper cover. It took about 5 seconds per side, very very very easy to install and fills the evo grill nicely.

snip these clips to get it to fit:

02-20-2007	#5
scheides flips McGee Cribbage Square Champion! Great Mahjong: Classic Champion! Mah Jongg Solitaire Champion! Mahjong Connect Champion! MuMu Champion! Join Date: May 2004 Location: Minneapolis, MN Drives: BeaterX Posts: 12,900	Re: Intercooler FAQ/Guide/Sticky Buschur Racing "Street" core/2G FMIC Kit. Measures 11x24x3.5" and was tested at <1psi pressure drop. I had this on my GSX w/ a bastard20G turbo. The car made 300whp (dyno dynamics) at 28psi and after 4 pulls the core was so hot it could cook meat on one end and cold on the other. Very efficient core, nice size as it seems to fit in a lot of places. Installation on my 2G required a lot of trimming, but I would buy it again as it comes with a nice set of all the piping needed. I have this same core w/ different end tanks on my Evo, it is sold as the 'Deluxe' FMIC. Stock turbo w/cams it made 294whp @22.5psi (peak) on 92 and again, the core gets a little hot on one end but after about 4 inches it is cool to the touch. Best part was installation. I did have to trim two teeny tiny clips that hold on the very outside upper corners of the mesh in the stock bumper cover. It took about 5 seconds per side, very very very easy to install and fills the evo grill nicely. snip these clips to get it to fit: