Quote:
Originally Posted by EvilEvo
Yes I ran load simulations but I honestly dont know how accurate they are considering that is not even the exact design on how it turned out. It is also hard for me to find out exactly where the load would be placed and at what direction, etc, etc... I mainly used the load testing part on small certain clusters. Another reason I couldnt really do much of the load testing is the way I stuck all the piping together. I did it in a way that none of them are technically connected in solidworks.... that way I could make a parts list with lengths and even print out the coped cuts for each pipe should I want to.
|
Hopefully the FEA will at least isolate the major stress concentration areas so you can address those.
Quote:
Originally Posted by EvilEvo
If you want let me know what the parts are and if it isnt too complicated Ill draw them up for ya.
|
That's the problem; they're rather complicated. I plan to send them to Advanced Design Concepts in Pewaukee.
Quote:
Originally Posted by EvilEvo
Like I said before, they got really pissed off at me after the whole intake manifold thing so since then I have not been awfully found of them.
|
Where is this thread at?