MitsuStyle - View Single Post

Andrew7dg · 09-28-2006

Just to add to this, I am going to run my 14b to the limit
Mods are (well, some assebly is still going on)
Dejon Exaust 2.5" - 3.0"
2g O2 housing
Evo 3 ported exaust manifold

The turbo and the O2 housing are going to get ported on friday!

also have a 255hp fuel pump
AFPR to go with that also

I have the 2g mas, not installed yet because I need:
550cc
S-AFC

and a 4 bolt rear end after I break the 3 bolt!
What are the limits of this little turbo for psi? 16-18?

Was going to try to have it ready by dyno days but with a limited budget i don't think I am going to make it in time. Would be interesting to see what it would make on this little turbo.

09-28-2006	#19
Andrew7dg Built it from scratch! Join Date: Mar 2006 Location: St. Paul Drives: Currently Mitsu-less Posts: 851	Re: How to make a Quick 14B Car? Just to add to this, I am going to run my 14b to the limit Mods are (well, some assebly is still going on) Dejon Exaust 2.5" - 3.0" 2g O2 housing Evo 3 ported exaust manifold The turbo and the O2 housing are going to get ported on friday! also have a 255hp fuel pump AFPR to go with that also I have the 2g mas, not installed yet because I need: 550cc S-AFC and a 4 bolt rear end after I break the 3 bolt! What are the limits of this little turbo for psi? 16-18? Was going to try to have it ready by dyno days but with a limited budget i don't think I am going to make it in time. Would be interesting to see what it would make on this little turbo. __________________ "A turbo, exhaust gasses go into the turbocharger and spin it, witchcraft happens and you go faster."