MitsuStyle - View Single Post

GVR-4579 · 05-01-2006

yea i would go with the puller/pusher hammer, mixed with lots of wd-40 method i think its the safest personally. if that doesnt work then i would goto heating as well as the puller and hammer but i dont like to heat bearings up too much. if you can't get a puller i can always custom fab one, but custom pullers get spendy and only work for one thing usually

and maybe you could rig a slide hammer on there somehow, i like those too, but im not sure if that will work well for this

05-01-2006	#6
GVR-4579 Join Date: Sep 2005 Location: lakeville, MN Posts: 119	Re: CV shaft is stuck in the hub yea i would go with the puller/pusher hammer, mixed with lots of wd-40 method i think its the safest personally. if that doesnt work then i would goto heating as well as the puller and hammer but i dont like to heat bearings up too much. if you can't get a puller i can always custom fab one, but custom pullers get spendy and only work for one thing usually and maybe you could rig a slide hammer on there somehow, i like those too, but im not sure if that will work well for this