|
Re: which is the best machine shop around shakopee?
For what its worth my 2.4 was machined by Wags and assembled by QPR. I have just under 25,000 miles on the engine and it is still going strong. I had the block bored .20 over torque plated to 100 ftlbs on arps. But it seems quite a few friends of mine have had bad experiences at Wags, one ex-employee told me a few dirty secrets about how they treat motors while they dissasemble them. Something about "ringing" the cranks to get the bearings to pop off. I can't recommend them.
Jim
|