MitsuStyle - View Single Post

Onefast99gsx · 03-22-2006

Use a punch and hammer those dents outward on those 2 big nuts. I didn't have access to an impact wrench at the time so i shoved a rag in between the gears and loosened the nuts. Whatever you do, DO NOT shove a screwdriver or something between the gears to keep them from spinning while you work the nuts off. There is a good chance that you will chip the teeth. Lay everything on a table in the same direction it came off. Some things look the same on both sides but in some cases, there are small differences, such as a notch or groove, etc...

03-22-2006	#11
Onefast99gsx Join Date: Sep 2004 Location: Wisconsin Posts: 1,411	Re: My Tranny Teardown Use a punch and hammer those dents outward on those 2 big nuts. I didn't have access to an impact wrench at the time so i shoved a rag in between the gears and loosened the nuts. Whatever you do, DO NOT shove a screwdriver or something between the gears to keep them from spinning while you work the nuts off. There is a good chance that you will chip the teeth. Lay everything on a table in the same direction it came off. Some things look the same on both sides but in some cases, there are small differences, such as a notch or groove, etc...