MitsuStyle - View Single Post

SchuttsR1 · 03-17-2006

I have a sanota block looking for a purpos, and have a few questions.

1. Could I use the 1st gen stock pistons? And what rings would I need to seal it up. Also what compression would that yeild. If not were can I get a set of pistons to work. Kinda want to keep the stock rods.

2. If I can use the stock pistons would ceramic coating them help with longevity? I am from the wonderful world of Rotaries and when you ceramic coat the face of the rotors it cuts down on heat damage to the rotors.

3. Does any one have a part number for the stubby shaft and the spacer for the crank to elimanate the b shafts?

Going to shot for 450whp on the stroker with a 20g.

Thanks

03-17-2006	#1
SchuttsR1 Yes, I am inbred Join Date: Dec 2005 Posts: 7	Stroking ??'s I have a sanota block looking for a purpos, and have a few questions. 1. Could I use the 1st gen stock pistons? And what rings would I need to seal it up. Also what compression would that yeild. If not were can I get a set of pistons to work. Kinda want to keep the stock rods. 2. If I can use the stock pistons would ceramic coating them help with longevity? I am from the wonderful world of Rotaries and when you ceramic coat the face of the rotors it cuts down on heat damage to the rotors. 3. Does any one have a part number for the stubby shaft and the spacer for the crank to elimanate the b shafts? Going to shot for 450whp on the stroker with a 20g. Thanks __________________ special:)