MitsuStyle - View Single Post

niterydr · 12-04-2005

As another weekend comes to an end, the manditory picture post is required.
I managed to finally modify, replace, and tweak my passanger side window. Now I have an enclosed cockpit! 20 months of a board proping up the window was long enough.
I also got the intake side of a head nearly finished. Just have to pop out the valve guides and make sure it is all even with emery cloth.

I figure 1-2 hours left on this head as far as intake side. The exhaust side should go much more quickly.
Then 1 more head after that, and im done. I figure I have less than 30 hours left (as I already have 15 into it).
Then john finished all of his welding on the "top" side of his cage.
Next up is the frame under it, then its sheetmetal time!!

Ryan got all of his rings filed/gapped. Once we get all of our rods and pistons (ryan and I) back from 'treatment' then we'll be assembling his motor. Probably next weekend, as its a 1 week turnaround.
Thanks for looking all, until next update....

12-04-2005	#50
niterydr back in the saddle again 24 Hours Rally Champion! 3D Pacman white house edition Champion! 3D Racing - Track 2 Champion! ATV Winter Challenge Champion! Bloody Pingu Champion! WRX Racing 2 Champion! Tournaments Won: 5 Join Date: Oct 2003 Location: Elkhart Texas Drives: 2015 Ram Quad Cab Hemi, 1999 FRC Corvette, 93 Stealth Turbo Posts: 6,411	Re: Finally getting stuff done one our cars As another weekend comes to an end, the manditory picture post is required. I managed to finally modify, replace, and tweak my passanger side window. Now I have an enclosed cockpit! 20 months of a board proping up the window was long enough. I also got the intake side of a head nearly finished. Just have to pop out the valve guides and make sure it is all even with emery cloth. I figure 1-2 hours left on this head as far as intake side. The exhaust side should go much more quickly. Then 1 more head after that, and im done. I figure I have less than 30 hours left (as I already have 15 into it). Then john finished all of his welding on the "top" side of his cage. Next up is the frame under it, then its sheetmetal time!! Ryan got all of his rings filed/gapped. Once we get all of our rods and pistons (ryan and I) back from 'treatment' then we'll be assembling his motor. Probably next weekend, as its a 1 week turnaround. Thanks for looking all, until next update.... __________________ My street car runs low 11's and my race car's personal best is a mid 11....