Thread: Check out this 4g63 rebuild
View Single Post
Old 10-24-2005   #16
niterydr
back in the saddle again
 
niterydr's Avatar
 
24 Hours Rally Champion! 3D Pacman white house edition Champion! 3D Racing - Track 2 Champion! ATV Winter Challenge Champion! Bloody Pingu Champion! WRX Racing 2 Champion!
Tournaments Won: 5

Join Date: Oct 2003
Location: Elkhart Texas
Drives: 2015 Ram Quad Cab Hemi, 1999 FRC Corvette, 93 Stealth Turbo
Posts: 6,411
Send a message via AIM to niterydr
Re: Check out this 4g63 rebuild
Quote:
Originally Posted by Goat Blower
-It would be nice if he used rubber/latex gloves when touching bearing material, fingerprints can create hot spots/marks/faster wear areas.

You've been hanging around Raptor too long. When you're putting assembly lube on bearing surfaces, fingerprints don't mean squat. That sounds like one of those lines he'd snowball the newbies with.

Steve
LOL! .
I just hate getting my hands dirty, I like using the gloves when im working with bearings. LOL .
__________________
My street car runs low 11's and my race car's personal best is a mid 11....
Last edited by niterydr; 10-24-2005 at 05:35 PM..
niterydr is offline   Reply With Quote