Quote:
|
Originally Posted by cudvig
mine does the same thing and its definately the shift cables, you should see them. you can tell they are bent. hahahah
-Colin
|
Well dont I fell stupid. I took the motor and tranny out, and pulled the tranny off, and right before I tore the tranny apart, my friend told me to check it again..........and it shifted through all the gears fine.
So i bolted it back onto the motor, and put the motor and trans back in, and it still shifted through the gears fine, so i hooked the cables back up and I noticed that the cable nearest to the motor (The one that goes back and forth, not side to side) is about 1.5 cm too long!! damn it!
figures... now I need to figure out how to shorten this cable up, are the 91-94 cables shorter or longer than the 90 ones? Because i have both sets.