MitsuStyle - View Single Post

**JET** · 09-18-2005

I talked to Shane a bit about this. The guy that had it before you probably didn't put a big enough spacer in when he got rid of the A/C. He bottomed the bolt out in the block and it was never holding the axle.

So, the bolt is probably bottomed in the hole. Not good. It is going to be pretty tight. Get a nail set, sharpen the point and try and spin the bolt out using it as a chisel with a hammer. That causes the least damage. The last resort should be drilling it out.

09-18-2005	#10
JET Is funding Exxon. Join Date: Oct 2003 Location: Ham Lake Drives: like a bat outta hell! Posts: 7,983	Re: Half shaft Driver's side Bolts... I talked to Shane a bit about this. The guy that had it before you probably didn't put a big enough spacer in when he got rid of the A/C. He bottomed the bolt out in the block and it was never holding the axle. So, the bolt is probably bottomed in the hole. Not good. It is going to be pretty tight. Get a nail set, sharpen the point and try and spin the bolt out using it as a chisel with a hammer. That causes the least damage. The last resort should be drilling it out. __________________ Is burning corn and stayin' warm! My motorcycle is stock and reliable, my Talon is neither!