DataLogger Software and connector question
 

I work for a Bio-Med company and we are assigned Handspring Visor's and I will be receiving my new Tungsten T3 in a couple of weeks. Most likely I will be able to hold on to the Visor for my personal use...but I would like to know where to buy or how to build a scan-tool connector and load the software onto either of these handheld units.

What datalogging software is the best bang for the buck?

Re: Anyone have Diag Port cable for Visor or T3?
 

Just create a WTB ad for the part you need and then edit this thread to just a tech question. Then you will be able to keep them seperated. I will leave this here, just take the WTB part out of it.

CRAIG

Re: Anyone have Diag Port cable for Visor or T3?
 

Done...Thanks CRAIG! :D

Re: Anyone have Diag Port cable for Visor or T3?
 

Go to pocketlogger.com thats the software I use on my Visor platinum.

They sell the cables on that site as well as the software. I know there is freware software out there but I dont think its as nice.

Either go pocketlogger or go full on DSMlink 1G. That is what I would do if you have the money.

Re: Anyone have Diag Port cable for Visor or T3?
 

I could/can make them for a laptop. I dont really have the time though. I made one for a palm but never got around to testing it. LightningGSX could probly make you one.

Re: Anyone have Diag Port cable for Visor or T3?
 

I have a device that plugs into the OBDII port on a 2G DSM and accepts a serial cable from a palm. Is this what you need? I used it with palmstein and it worked quite well.

Jim

Re: Anyone have Diag Port cable for Visor or T3?
 

Actually I have already ordered the cable I needed. But I do not think your OBDII would work on a 94 TSi would it?

-Kenny

Re: Anyone have Diag Port cable for Visor or T3?
 

Nope, I'm sure it wouldn't.