![]() |
Anyone wire in a 2G MAS in a 1G/Galant VR4?
As the title states, has anyone here wired a 2G mas in their 1G/Galant VR-4? I looked on the vfaq and I am still not really comfortable cutting up wires and soldering them up. Was it really that easy and if there are any tips for someone who has never done it before? I ask this because I have done a decent amount to the engine and I think with proper fuel tuning that my car can run more to its potential. Reading from other VR4 owners, if not going for insane horsepower, going with a 2G mas, 550 injectors, fuel pump, and chip along w/other mods (turbo, exhaust,etc...) will enable to car to run more smoothly.
Here is what I have so far (By the way, I have a 91 Galant VR4 hence the VR4 by my signame) -Rebuilt motor w/new bearings, new gaskets from the block up, ross pistons 8:5:1, eagle rods, 3 angle valve job, milled the head, hot tanked both the block and head... -ported small 16G -mildly ported evo III manifold -2.5" turbo back exhaust -ACT 2100 w/13lb flywheel -MBC @ 14psi -550 fic injectors -JDM FMIC (from an 89 Galant vr4) -I have a 255 walbro, but I'm waiting on ordering an AFPR and a 2G MAS and chip... Hopefully if all thing turn out alright, the Galant could go to low 13s on pump 93 octane or maybe even high 12s. Who knows... |
Re: Anyone wire in a 2G MAS in a 1G/Galant VR4?
I've done it.Its pretty easy, just make sure you cut and solder each wire one at a time, otherwise you can mix up the wires.The first one I did, I just chopped all the wires, not realising there were two of the same color.So I ended up having to trace the wires back to the ECU.
|
Re: Anyone wire in a 2G MAS in a 1G/Galant VR4?
|
Re: Anyone wire in a 2G MAS in a 1G/Galant VR4?
Quote:
|
All times are GMT -5. The time now is 01:21 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.