MitsuStyle - ? About degreeing cams

MitsuStyle (http://www.mitsustyle.com/forums/index.php)

- Turbo / Engine / Drivetrain (http://www.mitsustyle.com/forums/forumdisplay.php?f=91)

- - ? About degreeing cams (http://www.mitsustyle.com/forums/showthread.php?t=32174)

4seasons69

10-03-2012 03:58 PM

? About degreeing cams

Ok so my cylinder Head is going to the head head shop this week I'll be running all the same components plus some porting and polishing. so once I get that back the engine will be going back together. Getting to my question. The cams were degreed when the old engine was assembled. Now if the cam gears aren't touched once everything is put back together would the cams need to be degreed again? Any help is appreciated!

Shane@DBPerformance

10-03-2012 04:00 PM

Re: ? About degreeing cams

If the head got milled or you use a different thickness head gasket then they probably need to be checked.

4seasons69

10-03-2012 04:01 PM

Re: ? About degreeing cams

Also can the cams be degreed with the engine in the car?

4seasons69

10-03-2012 04:02 PM

Re: ? About degreeing cams

Quote:

Originally Posted by Shane@DBPerformance (Post 415514)

If the head got milled or you use a different thickness head gasket then they probably need to be checked.

Well old head is junk. I have a new good core that will be used. So probably should at least be double checked

Shane@DBPerformance

10-03-2012 04:06 PM

Re: ? About degreeing cams

If it's a different head, then it needs to be re-degreed.

4seasons69

10-03-2012 04:08 PM

Re: ? About degreeing cams

Quote:

Originally Posted by Shane@DBPerformance (Post 415517)

If it's a different head, then it needs to be re-degreed.

Awesome! That's what I needed to know. Thanks!

All times are GMT -5. The time now is 03:56 PM.