MitsuStyle

MitsuStyle (http://www.mitsustyle.com/forums/index.php)
-   Turbo / Engine / Drivetrain (http://www.mitsustyle.com/forums/forumdisplay.php?f=91)
-   -   Blow Off Valves (http://www.mitsustyle.com/forums/showthread.php?t=3135)

Jana 05-24-2004 01:14 PM

Tell me how they work? (continuing from previous off topic thread)

A//// Guy 05-24-2004 01:14 PM

Move that stuff that pertains to the mazda and its setup in here then if it doesnt belong the FMIC topic. Which I think is fine as it is not that off topic because the BOV and its operation are directly related to the setup you guys installed.

Matt D. 05-24-2004 01:23 PM

Quote:

Originally posted by DSMChick@May 24 2004, 12:14 PM
Tell me how they work? (continuing from previous off topic thread)
Blow off valves are simply valves that release pressure between the turbo and the throttle body. They are activated by vacuum, negative pressure in the intake manifold. This vacuum happens when the throttle is closed, and the engine is sucking air in faster than the throttle body is providing it. When vacuum is created the blow off valve (BOV) opens. Under normal circumstances the BOV should never open at idle. If it does certain things must be done so that the car operates properly.

LightningGSX 05-24-2004 03:20 PM

Its actually a good thing if they open at idle or anytime you aren't building boost(recirculating setup that is), it will give you much better throttle response and quicker spool.Most factory BOV recirculating setups are designed to do just that, thats why OEMs usually call them Compressor Bypass Valves.Ideally you'd want the BOV open anytime the boost is less than 0 psig, and open when the throttle plate closes of course.

A//// Guy 05-24-2004 10:26 PM

So since no one will try an answer my previous question about how my stock BOV would blow air out at idle, I did some research. It seems as though I was right an a few of you were wrong.

At idle the BOV will spill air out of the BOV because there is positive pressure in the piping before the TB, and the vacuum in the intake manifold will slightly open the BOV.

I verified that with this page http://www.racetep.com/bypass.html

So in this case the Mazda was running like crap (rich not lean) because some air that was being metered was being released out of the BOV and therefore creating a rich idle.

A strong BOV like a tial shouldnt open at idle like a stock one does so if it does there is either really strong vacuum or the spring is faulty.

LightningGSX 05-24-2004 11:17 PM

You are wrong, I'm not even gonna bother to look at that page because I'm guessing they are wrong also.At idle(when MAP is vacuum), the air inside the I/C piping is below atmospheric pressure(or at max in equillibrium with atmospheric), they is no way(without breaking the 2nd law of thermodynamics) air can flow out of the BOV.Its possible your turbo(spinning at idle) brought the air inside the pipes above atmospheric(not likely), in which case it could flow out.In the case of the Mazda, it was in fact running LEAN, causing shitty idle.

LightningGSX 05-24-2004 11:21 PM

BTW IIRC the Tial BOV comes with a .7 Bar spring, which means it will open at 9.24 in Hg of vacuum, most vehicles will pull twice that at idle.

A//// Guy 05-24-2004 11:29 PM

So according to you my car was not pushing air out of the BOV at idle.. I guess I was lying and I guess a few pages I visit were also wrong.

I am going to have to do a few test and find out the results becuase I guess no one can totally clarify.. even though I tested it already.

Mike or Josh you want to chime in on why my car is an exception then?? At first I use to think the same way as you guys did but I just dont believe it... It does make total sense but not in my case for some reason.

Jacek 05-24-2004 11:34 PM

blowing air out? you running anti-lag or something? ;)

blow off valve is just a pressure relief valve. works in the same manner as a boost controller but different use..

JET 05-24-2004 11:57 PM

Quote:

Originally posted by EclipseTurbo@May 24 2004, 09:26 PM

I verified that with this page http://www.racetep.com/bypass.html

So in this case the Mazda was running like crap (rich not lean) because some air that was being metered was being released out of the BOV and therefore creating a rich idle.

Anyone else find a Starion page at that link? I don't see anything about a Mazda and nothing on there said they were blowing air out.

Just think about it though. If you are at idle and floor your car, how high does the boost gauge go? Usually to -2 in hg or so. This is under atmosperic, so it can't be pressurized.

I am a little intrigued by the fact that it is in the IC piping though. That is a smaller area and could possibly have a higher pressure, but I still don't see any way that the compressor is putting out more air than the engine is using at idle.

LightningGSX 05-25-2004 12:06 AM

Quote:

Originally posted by EclipseTurbo@May 24 2004, 10:29 PM
So according to you my car was not pushing air out of the BOV at idle.. I guess I was lying and I guess a few pages I visit were also wrong.

Easy there, I don't remember accusing you of lying.As far as the pages you visited, there is no shortage of incorrect information on the net.

A//// Guy 05-25-2004 12:24 AM

Alright well I cant win so Ill just "lose." I guess ther is no logical explanation for what I have experienced. Oh well.

LightningGSX 05-25-2004 01:01 AM

There's obviously a logical explanation, let me check out your car sometime and I will give you one.

Enes 05-25-2004 01:04 AM

his turbo is so good that it is creating a preasure while its idling...

-E

A//// Guy 05-25-2004 11:12 AM

Well now we switched my BOV to a tial so I havnt tried to see if any air comes out at idle. But Ill be at QPR hopefully soon so you can check it out.


All times are GMT -5. The time now is 08:34 AM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.