Torque Solution Evo X gate selector pivot bushing install review
I've been in contact with Mike @ AWD about testing a prototype Torque Solution gate selector pivot bushing made from delrin rather than the typical brass/bronze like the current AMS and TWM offerings on the market. I already have the AMS in my car but said I'd be willing to install it on my friend's car.
My initial impressions were good, simple bushings but they looked properly manufactured, and look at that, made in the USA. http://www.mitsustyle.com/photopost/.../IMAG02141.jpg Following AMS' instructions we got the stock assembly removed and took out the stock plastic & rubber bushings. http://www.mitsustyle.com/photopost/.../IMAG02181.jpg After fully cleaning all the stock components, using a thin coating of grease, the new tube bushing slid right in with a little thumb pressure; this is where the delrin differs from the metal bushings, the metal ones require tapping with a hammer. During reassembly we used a light coating of grease on all contact and pivot points. When installing the delrin flat washer be sure the side with the lip fits down into the groove; tough to explain but it'll be obvious once you're actually doing it. http://www.mitsustyle.com/photopost/.../IMAG02171.jpg http://www.mitsustyle.com/photopost/.../IMAG02161.jpg http://www.mitsustyle.com/photopost/.../IMAG02201.jpg Before installing the assembly back into the car be sure it moves freely and isn't sticking or binding, if it is you may need more grease or to loosen the 12mm nut that holds everything together. Start to finish it took less than 45 minutes, but I had done mine last year so the experience helped. If you're doing it alone for the first time I'd say you can expect it to take about an hour to 1.5 hours if you go slow and take your time. As soon as I get my friend's driving impressions review I'll get it posted. Before this install his existing shifter mods were: Cobb short-shifter Cobb shift knob Torque Solution base bushings His driving impression review: Quote:
Adam at MAP has a really good relationship with Mike so be sure to go through him! |
Re: Torque Solution Evo X gate selector pivot bushing install review
Driving impression review added.
|
Re: Torque Solution Evo X gate selector pivot bushing install review
Awesome! I like the delrin solution, the metal ones are nice but they are a pretty tight fit!
|
Re: Torque Solution Evo X gate selector pivot bushing install review
Quote:
|
All times are GMT -5. The time now is 02:00 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.