tranny will not go in 1 3 5
 

I have a 92 awd and a 92 tranny and the cables are a 92 and same with the brackets and it will go in to 2 4 r but no 1 3 5 at all it acts like it is in neutral and thought what to do.

Re: tranny will not go in 1 3 5
 

Adjust the cables?

Re: tranny will not go in 1 3 5
 

I did that and that did not work and the new ones are not adjustable

Re: tranny will not go in 1 3 5
 

When you put it in first does it stay in the first gear position? Try taking the cables off and shift th tranny by hand. And see if you can get it in 1st 3rd and 5th.

Re: tranny will not go in 1 3 5
 

it goes when you do it by hand.

Re: tranny will not go in 1 3 5
 

any other thoughts on it i am open to any thoughts

Re: tranny will not go in 1 3 5
 

your adjusting it on the shifter right? they should be adjustable there.

Re: tranny will not go in 1 3 5
 

ya i am and it will not work new ball and fork to

Re: tranny will not go in 1 3 5
 

Sounds like a linkage problem.

Re: tranny will not go in 1 3 5
 

Where would the problem be? Do you have a idea? I thought it would be a linkage problem but where?

Re: tranny will not go in 1 3 5
 

any idias would be nice i have tryed everything

Re: tranny will not go in 1 3 5
 

If it shifts just fine by hand with the calbes not connected I would think it'd be a problem with the cables that moves with moving the shifter up and down.

If you disconnect the cables from the trans, does it still seem like it locks you out of 1/3/5?

Re: tranny will not go in 1 3 5
 

ive seen the car. its 100% in the cables or the cable mounts. its about half an inch too short to push it into those gears, even when adjusted all the way out. i personally think either the; 1cables are the wrong cables, 2 the cable bracket on the trans is the wrong one or something along those lines

Re: tranny will not go in 1 3 5
 

that is what i am thinking to but how to get the shifter off of the old tranny and put it on the new one.

Re: tranny will not go in 1 3 5
 

i think swapping that arm will solve all but you shouldnt have to, there should be something else that would make it work with the arm thats in it. but if we can get your arm off then i believe youl be golden

Re: tranny will not go in 1 3 5
 

ya i dont know what to do i am out of idias so that is what is going to happen

Re: tranny will not go in 1 3 5
 

Take a good pic of the cable bracket that bolts to the trans.

Re: tranny will not go in 1 3 5
 

i got it to go in 3 5 but still no 1 but all the other gears work any body has this problem at all and i adj the cables all the way.

Re: tranny will not go in 1 3 5
 

Is it possible that you have the cables switched, or are they the same length? Have you actually driven the car (reverse in the car is what the cables are putting the tranny in)? Just some more ideas.

Re: tranny will not go in 1 3 5
 

ya i have driven the car and no the cables r not switched at all it going in 1 in the car not on the tranny when i let the clutch out the car dosnt move.