MitsuStyle - Dsm project

MitsuStyle (http://www.mitsustyle.com/forums/index.php)

- Mitsu vehicles for sale (http://www.mitsustyle.com/forums/forumdisplay.php?f=77)

- - Dsm project (http://www.mitsustyle.com/forums/showthread.php?t=25162)

Asking price $2600 ( The price has changed all the issues have been fixed) OR BEST OFFER I really need to get rid of this thing ASAP
The car runs and drives. Stock swyrlys have been curbed for some 16 Inch Enkei Wheels. If no body wants to pick it up by the time i am completely finished with the car I will not be selling it any longer!

1991 Eagle Talon TSI 1G-

Modifications:

Engine:
Stock Rebuilt 6 Bolt Block (Ceramic Paint Coated)
ARP Head studs
Balance Shafts Eliminated
Red Stock Valve cover included( Be ware it is ugly) ^_^ new one would almos complete the Engine bay.
New PCV valve

Exhaust:
Ported 2G 02 Housing (Ceramic Paint Coated)
2.5" Custom Straight Turbo back Exhaust w/Magnaflow Muffler
*come with stock 1G exhaust manifold.
*If buyer is interested i have a Tubular manifold as well

Intake:
3" Short Ram Intake Pipe (Ceramic Paint Coated)
Ported MHI Evo 3 16G Turbocharger
Stock maf (3G 501 MAS included if wanted)
QPR Throttle Body FIAV Blockoff Plates

Fuel:
560CC EVO VIII Injectors ( Brand new Mitsu Dealer O Rings & Lower Injector seals)
Walbro 190 LPH Fuel Pump*

Electronics:
Eprom ECU w/Keydiver Chip
TurboSmart Boost Tee MBC
Greedy Turbo Timer (Not installed)

Drivetrain:
ACT 2600 Clutch Kit
Roller Skate Shifter Bearings
Non-Cruise Shifter Cable

Suspension & Brakes:
Option Import Front Strut Bar
Stainless Steel Rear Brake Lines

Adaptive One Front Brake Pads*
NAPA Safety Stop Rear Brake Pads*
Blank NAPA rotors
New Tie Rods Both Sides
New Wheel Bearings both sides
(Every thing is NEW)
*Does need some new shocks up front*

Interior:
2G DSM Leather Shift Knob

Exterior:
Enkei 16inch wheels complete set. (Good tread on tires)

Miscellaneous:
FIAV Eliminated
Emissions Eliminated
A/C Eliminated
Cruise Control Eliminated
Catalytic Converter Eliminated
Idle air control motor eliminated.( Unless you want to carry a screw driver everywhere you go it needs a replacement motor)
Winter Tires are next inline.
The car is getting final finishing touches.

If no body wants to pick it up by the time i am completely finished with the car I will not be selling it any longer!

Thank you for your time. I WILL CONSIDER ALL OFFERS.

omg a black cherry.

is it awd?

Yes, It sure is a awd Shifts nice to!

So what does it need?

Will you please be honest with people and tell them what compression numbers the motor makes? So someone doesn't get taken for a fast one like you did ;)

Quote:

Originally Posted by Alpha D (Post 316007)

Drivetrain:
Non-Cruise Shifter Cable

Did you mean non-cruise throttle cable?

Quote:

Originally Posted by s1ngletracker (Post 316074)

Will you please be honest with people and tell them what compression numbers the motor makes? So someone doesn't get taken for a fast one like you did ;)

I think he is being honest and really doesn't know the compression numbers. If it were me buying the car I would just bring a compression tester with when I went and looked at it.

What all is wrong with the car? What needs to be done to fix it?

I will tell you every single thing that i have found out about the car. NO WAY ON EARTH WILL I BE UN HONEST! For everyone to know the number on my compression tester were 120 115 110 the last one was between 115 and 110. That in theory is very bad. We tested my friends motor it to read low way low as well. We came to the conclusion that my tester read about 15psi low. He ran another test on his vehicle with a different gauge it showed 15psi higher on all Cylinders. if you have any more questions please feel free to send me a pm.

As of now nothing else needs to be fixed except for installing the new side mount intercooler i picked up today. Put in a turbo timer which i have if you want. Then you would need to get a master cylinder extension rod. ( I am sorry i do not remember the exact name of the rod needed)

-Turbo Coolant leak Fixed
-Starter Fixed
-Maf fixed have 3G can come with the car
-You might want to look for a few trim pieces.
*Notice the car Runs & Drives Now.

I have put close to $700 i am taking a Huge hit. But i really want a VR4

Thank you very much s1ngletracker for making me feel even stupider then i did. I trusted a fellow member. . . . stuff happens end of story. He said he did not know about the motor. I will believe him.

I know that for some of the people on this forum the car would be a piece of cake to fix. I like the car its FINALLY DRIVABLE! After all the time money and effort into it. So please dont make it seem as if i am trying to unload my burdens on a UN suspecting person. I will post it up on Craigslist for 3k once i feel like Ripping some one of!

Depends on what you have.

96 pontiac grand am gt, with new plugs, wires, front brakes, serp belt, tensioner etc. check engine light is on for an o2 sensor. Been my daily driver for a while now. Oh, and brand new tabs getting bought tomorrow.

Sounds Like a Solid Car. Im not into Grand am's though sorry, Not interested.

What is wrong with the car now??? anything on the compression?? Idle air control motor eliminated.( Unless you want to carry a screw driver everywhere you go it needs a replacement motor).. what does this effect on the car?? running and driving?? what turbo??

If you are interested rocket send me a PM. The car does not have any problems except for one huge boost leak. I have build a boost leak tester kit. I am in need for a compressor. To answer your question quickly it has a MHI Evo III 16G

You might of missed the Build List Above refer to it incase you want quick reference as to what has been done to the car.