holset question
 

what size is the thread for the oil feed on an hx35? i cant find it anywhere.

Re: holset question
 

12 x 1.5

Re: holset question
 

im trying to find a fitting that is 90deg with a 4-an on one side... and i cant find anything

Re: holset question
 

That might be tough.

Re: holset question
 

Yeah that might be tricky. Something to consider is juts getting a straight adapter fitting, and using that with a feedline that has a 90* -4an end on it. That's how mine is setup.

Re: holset question
 

same here, it will be ur best bet

Re: holset question
 

I have a m12x1.5 to -4 an fitting. my oil line has a 90 built in.

Re: holset question
 

Go on Dsmtuners they have over like 2000 pages on Holsets. Including a specific one on how to run the oil feed. I plan on getting one when i get home from Iraq. Sorry dont mean to refer you to another site. I just know they have a lot of stuff on there about Holsets. Awesome turbos, put up numbers when she gets dynoed. Heres a link
http://www.dsmtuners.com/forums/turb...-part-7-a.html

Re: holset question
 

that would work but i have to run an oil restrictor at the turbo. i think it will be to tall.

Re: holset question
 

I have an "Extreme PSi" oil feed line from the oil filter housing with a holset adapter fitting. I use an FP journal bearing restrictor.

I have the 90 degree fitting on the OFH, then the FP restrictor/filter attached, then the -4an line which goes to the a built in 90, then the M12x1.5 adapter on the turbo.

Re: holset question
 

I did the nitrous line deal, I have a gauge at home so essentially I will be able to tune my oil psi at the turbo

Re: holset question
 

I bought a banjo fitting on ebay. It works perfect. The hole in the banjo bolt is .060, so it's a restrictor already too, if you want more pressure drill it out a little.