Fidanza Torque Spec
 

Anyone off hand have torque specs for the surface plate on an aluminum Fidanza flywheel?

And the flywheel to the block? I remember it being 96ft/lbs or so.

Re: Fidanza Torque Spec
 

I just did mine last night. I torqued the flywheel to the crank at 100 ft/lbs with red loctite.

For the pressure plate I used 30 ft/lbs.

Are you referring to the replaceable surface for the "surface plate"? That I'm not sure on, I bought a new flywheel.

Re: Fidanza Torque Spec
 

~10lb/ft with a little loctite. Also the torque spec for a 6bolt is 96lb/ft and a 7bolt is 55lb/ft. I torque a 6bolt to 75 with red thread locker so the bolt does not break.

Re: Fidanza Torque Spec
 

Thanks a ton guys, I needed both of those.