Tourqe specs?
 

Does anybody have all the tourqe specs for the 4G63T motor? Or know where i can get them besides the gay chiltons or haynes manuals?

Re: Tourqe specs?
 

www.vfaq.com has some specs, but they're hard to find.

Try www.plymouthlaser.com for some of them.

I believe there is a "CAPS" out there for DSM's. But I can't find the link anymore.

Re: Tourqe specs?
 

What's wrong with Haynes manual?

Re: Tourqe specs?
 

CAPS is a parts lookup program that Mitsu uses, lots of us have it. It doesn't have torque specs. Use the Haynes, it's fine.

Re: Tourqe specs?
 

Ahh, Thanks. Could you link me to it? Or somebody? I could use this.

Re: Tourqe specs?
 

ok i guess the haynes manual will do..

Re: Tourqe specs?
 

If you want to come down to eagan im sure i can print them all off for you using Mitchell On Demand. Otherwise just buy a haynes this most likely wont be the only time you will need these specs.

Re: Tourqe specs?
 

How about the DSM cd? or what were you looking for?

~John

Re: Tourqe specs?
 

In my chiltons manual it doesnt state a final torque spec for the crank bearing caps. it uses a low torque value then says finish with a 1/4 turn. I am looking for the torque specs on:

crank bearing caps
rod bearing caps
and the recommended torqueing sequence when using a stock mitsu composite headgasket.

Re: Tourqe specs?
 

All that info is in the Chilton...

Re: Tourqe specs?
 

What year engine and are they factory parts you are installing?

~John

Re: Tourqe specs?
 

always use a chilton manual. hayne's sucks. they leave stuff like that out

Re: Tourqe specs?
 

alldatapro told me 34-36 ft lbs for the rod caps...