intake hard pipe
 

im trying to replace my stock plastic intake tube with a hard pipe. i noticed that there is a difference in size to where it bolts to the turbo and to the intake box or maf.. what size cupplings would i need on both sides and where is a good hard pipe with that kind of bend?

Re: intake hard pipe
 

What size of turbo do you have? Stock is 2.25".

Re: intake hard pipe
 

ya i have stock.

so i will need a 2.25" from the turbo, to im guessing 3.0 or 3.5 to the maf..

still looking for a pipe thats bent like that

Re: intake hard pipe
 

if i remember right, theres two hoses that run off that intake tube into the engine.. will getting an intake pipe with one nipple and plumb a T fitting on it work??



http://cgi.ebay.com/ebaymotors/Mitsu...25822683QQrdZ1

Re: intake hard pipe
 

you can just cut off the elbow and put in a 45* 2.25" hard pipe and use the rest of the stock rubber one. I think there is a VFAQ on it.

Re: intake hard pipe
 

Dejon makes some pretty decent intake pipes for good prices.

Re: intake hard pipe
 

dejon as in the website or a member? i found the write up but its with plastic pvs pipe.. i learned that those two hoses can be vented to the atmosphere or plugged with fuel filters

Re: intake hard pipe
 

www.dejontool.com

Don't use PVC under your hood, if you insist on going the Home Depot route (which you shouldn't) use ABS plastic instead.

Re: intake hard pipe
 

thanks!