Example of our Stage 2 Cylinder Head
 

This was just purchased from our website, thought we would share some pics. Let us know what you think!

Stage 2 MAPerformance Cylinder Head

•Hot Tank
•Glass Bead Blast
•Fully Pressure Checked
•Fully Decked Head Surface
•Stage 2 Port/Polish
-Stage 1+
-Full porting of the bowls
•5-angle Valve Job
•New Valve Stem Seals
•1mm Oversize SS Valves
-SI Nitrided (In this case)
•Your Choice of Springs and Retainers
-Manley (In this case)
•Reassembly

Check them out here:

http://www.maperformance.com/store/p...cat=400&page=1

Re: Example of our Stage 2 Cylinder Head
 

I don't see any porting or polshing in the bowls in those pictures. The intake dividers still have the casting marks on them. :confused:

Re: Example of our Stage 2 Cylinder Head
 

Yeah it's hard to tell from these picks, and it was glass bead blasted after the port work. A stage 2 from us is pretty minor in regards to porting:

Stage 1 $125

• Minor clean up of casting flaws
• Minor clean up of bowl transitions

Stage 2 $250

• Stage 1+
• Full porting of bowls

Stage 3 $450

• Stage 2+
• Porting and polishing of entire intake and exhaust

Stage 4 $550

• Stage 3+
• Enlarging exhaust ports

Stage 5 $750

• Stage 4+
• Removal/Installation of guides
• Porting of guide bosses

Re: Example of our Stage 2 Cylinder Head
 

Hey Chris, how much for you guys just to port my head and get it pressure checked and decked. I want like a stage 3 done. I'll bring in the head all disasembled. Thanks AJ

Re: Example of our Stage 2 Cylinder Head
 

Check your PM's

Re: Example of our Stage 2 Cylinder Head
 

Do you guys do 5 angle valve jobs and if how much for it with a stage three head?

Re: Example of our Stage 2 Cylinder Head
 

Absolutely! Check it out here:

http://www.maperformance.com/store/p...cat=400&page=1