6 bolt Swap Question
 

When using a 1g intake manifold, Where can i find the Brake Booster to T in the MAP sensor ?? Not sure if this is correct info but any help would be greatly appricated.

Also when doing a FULL 6 bolt swap , Do the vacume lines get changed around in a 2g turbo GST ??

Re: 6 bolt Swap Question
 

Are you going to keep the emissions stuff?
The brake booster line is the BIG vacuum line that goes from the brake booster(behind the master cylinder) to the back of the intake manifold. I did it this way for a min then it looked to Ghetto. SO I tapped into the P teminal on the throttle body instead. ALSO there is a part you can buy that is just for this purpose(I cant find it right now). Also its a MDP sensor not a MAP :)