??? On piston location
 

Are pistons 1 and 4 supposed to be the same height and 2 and 3 supposed to be the same height when sitting in the block?

Here some pics
http://www.cardomain.com/member_page...65_57_full.jpg
http://www.cardomain.com/member_page...65_57_full.jpg
http://www.cardomain.com/member_page...65_59_full.jpg

Is my head still good? Is the damage just to that rod?

Re: ??? On piston location
 

Yep

Re: ??? On piston location
 

so if Im looking at the block while its in the car the 2 and three are diffrent height what did I break

Re: ??? On piston location
 

Maybe you bent a rod. Or your perception of reality.

Re: ??? On piston location
 

Thats what I was thinking a rod Ill have pics up in a second

Re: ??? On piston location
 

It would have to bend pretty far to sit that high. Broken maybe. Seperated from crank. I'm inexperienced with internals though, so my guesses are probably crap.

Re: ??? On piston location
 

Yea, your shit is broke. Is the head all smashed up?

Re: ??? On piston location
 

Great, I dont know Ill go check the head what should I look for? And what should I take pics of so you can see

Re: ??? On piston location
 

Broken shit?

Re: ??? On piston location
 

Look for carnage, CARNAGE. And post up pics for us to see! Carnage always gets me pumped up!!

Re: ??? On piston location
 

All the valve ends look ok, all in original location. I dont know if the rockers and cams could of been damaged by this but they seem to look alright as well. Nothing fell out of the head when I removed it.

Re: ??? On piston location
 

I had a head with 10 bent valves once, and it looked fine too. You're shit's prolly f-ed. Lets see pics.

Re: ??? On piston location
 

Here ya go in order from left to right
http://www.cardomain.com/member_page...65_60_full.jpg
http://www.cardomain.com/member_page...65_61_full.jpg
http://www.cardomain.com/member_page...65_62_full.jpg
http://www.cardomain.com/member_page...65_63_full.jpg
http://www.cardomain.com/member_page...65_64_full.jpg
http://www.cardomain.com/member_page...65_65_full.jpg

Re: ??? On piston location
 

How that happen?

Re: ??? On piston location
 

Something is definatly broke! The rod is either broke or bent and i cant tell anything on the head though.

Re: ??? On piston location
 

seems to me like piston 1 and 4 don't look too great on the head. black deposits.

most likely your connecting rods are bent. expect lots of surprises in that oil pan.
good luck
yy

Re: ??? On piston location
 

Broken #3 rod, otherwise known as "your shit is fubar'd"

Re: ??? On piston location
 

Motor's gone, start over.

Re: ??? On piston location
 

I like your thinking!!!
\
Yeap I pushed down on piston #3 and it sunk down so conneting rod is snaped.

Re: ??? On piston location