AN Fittings
 

Im going to Install my external oil cooler with stainless line and AN fittings. Where is a good place to get these fittings? Also Whats a good brand? Any local place have these?
Thanks,
Mike

Re: AN Fittings
 

Re: AN Fittings
 

For local places, check hydraulic stores/shops. That's where i bought mine. $0.82 for a -4 to 3/8" 90* fitting, which is over $4 at the site listed above.

Re: AN Fittings
 

I checked ANplumbing and its $160 for everything I need. Thats why Im trying to find something else.

Where is there a hydraulic store need the cities?

Re: AN Fittings
 

I had just installed an external oil cooler on my car, but it had all the fittings i needed..stock ones (i used a different oil cooler, so it won't blow out on me, like shane's once did). I needed fittings for that oil filter housing for the oil feed though, since the frame was in the way..i got a 90 deg. bend, and a male tl male fitting. I got the fittings from mas, right off of uni.

-A. Swift

Re: AN Fittings
 

Not sure.

www.yellowpages.com

I'm in Eau Claire, and just happened to stumble on this hole-in-the-wall shop that had them.

Re: AN Fittings
 

jegs and summitt sell AN fittings also

Re: AN Fittings
 

If you make a list of AN fittings you need, I could get them for you a lot cheaper than $4 a peice.

Re: AN Fittings
 

I will definitely keep that in mind, that shit is spendy.

Re: AN Fittings
 

That racing shop on the east side of 280 on university has a ton of them.

Mas Racing Products
2288 University Ave W, St Paul, MN
(651) 644-6811

Re: AN Fittings
 

Ive got them at TNT I think there in blane and MAS.

Re: AN Fittings
 

PM Sent.
Maybe Ill go check out MAS one Of these days too. Has anyone been to that place on uni kinda by MAS next to subway on the north side of UNI? It starts with a P or something. Its a plubming store I think and they sell Tbolt clamps. I wonder if they sell fittings.

Re: AN Fittings
 

propulshun..um..no.

-A. Swift

Re: AN Fittings
 

You are thinking of Pirtek.

Re: AN Fittings
 

what are the specs of fittings and line we need to do AN fittings for the external oil coolers?

Re: AN Fittings
 

Oil cooler-
7/8X14 to -8AN
-8AN 120 degree fitting
Filter housing
M16X1.5 to -8AN
-8AN 90 degree fitting

Re: AN Fittings
 

Awesome. Thanks much.

Re: AN Fittings
 

Sorry to bump this from the grave, but I need to get several An fittings this week and this place appears to have it's number disconnected. Can anybody confirm that they are still around?

If not, where should I go in the TC?

Thanks!

Re: AN Fittings
 

Full Blown had a decent selection at one time, give them a call.
www.fullblownmotors.com

There was also a shop in the northern suburbs at one point but I can't for the life of me remember the name. When I bought fittings before I just ordered them from Jegs or Summit.

Re: AN Fittings
 

MAS is closed for good, aggressive hydro. might have what your looking for, they are located in blaine.