FS: DIY - DSM SMIM Parts
5 Attachment(s)
I still have my parts from a long time back when I was going to make my own intake manifold for my Talon. I don't even own a DSM anymore so no use for it, lol.
- 4" x 4" x 1/8" wall (16" long) - Square extruded Aluminum to act as plenum - 4" x 1/2" thick (16" long) - Aluminum plate to act as the bottom of the plenum for radiused holes - (2) 4" x 4 x 1/2" thick - Aluminum plates to go on the ends of the plenum (one of which you would drill/cut to be TB flange) - 3/8" thick aluminum Intake Manifold Head flange (I believe these were for 1G sized ports). Only thing you still need is some 2 1/4" piping for the runners. I was basically going to mimic this guys setup http://www.dsmtuners.com/threads/bui...nifold.273139/ $55 shipped $35 if you come pick it up. http://mitsustyle.com/forums/attachm...1&d=1475184490 http://mitsustyle.com/forums/attachm...1&d=1475184490 http://mitsustyle.com/forums/attachm...1&d=1475184490 http://mitsustyle.com/forums/attachm...1&d=1475184490 http://mitsustyle.com/forums/attachm...1&d=1475184490 |
All times are GMT -5. The time now is 08:17 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.