Alot of 1g Parts
 

I am pulling everything off of my setup so I can go bigger!
What I have... The price is to shoot me a reasonable offer!
Evo8 fuel pump
Evo8 injectors
1g head with less than 1000 on rebuild
jdm fmic with piping and bov ( This is small but it works)
2g ehaust manifold
small 16g with little shaft play
2 stock intakes
2 valve covers
a set of gauges( volt, water temp, air to fuel ratio not a wideband, boost, oil pressure)
light wieght crankshaft pulley
Contact me at 651-468-1647
Kevin

Re: Alot of 1g Parts
 

also everything you need to run ds-map version 2 or purchase version 3

Re: Alot of 1g Parts
 

Great seller; very honest and nice!

Re: Alot of 1g Parts
 

Thank You Kracka! And good luck on those Injectors let me know how that goes I would be interested to see how that works out. Nice Car!

Re: Alot of 1g Parts
 

I decided I am also going to sell a stock 4g63 block and a stock manual tranny. I would like 350$ for the block with about 80,000 miles on it. I was looking to get 300$ for the tranny. Engine runs good and trans doesn't grind and shifts smooth.

Re: Alot of 1g Parts
 

Pics of the crank pulley

Re: Alot of 1g Parts
 

what condition is the short block in? or is it the long block?

Re: Alot of 1g Parts
 

sorry I dont have a camera at the moment. It just looks like an aluminum crank shaft pulley

Re: Alot of 1g Parts
 

Well it depends on what you want. I bought the short block for 350$ I bought a head for 150$. I barely put any miles on it so if I were to sell every thing together I would hope not to loose money on the deal. It is in good condition. However if I were to pull it I would go through things while it was out (just gaskets and inspection and cleaning) other whise it runs great and I also have some king bearing left over for it as well.

Re: Alot of 1g Parts
 

also have 2 heads that just need some intake valves. The one is in really good condition with less tha a thousand on a rebuild the other one looks ok but not great.

Re: Alot of 1g Parts
 

also both heads have every thing needed to go with caps cams and rockerz

Re: Alot of 1g Parts
 

Your setup has two of everything? That's a good project. :P

Re: Alot of 1g Parts
 

how much do you want for the 16g?

Re: Alot of 1g Parts
 

um i think a 150$ sounds good to me

Re: Alot of 1g Parts
 

do you still have a head for sale?

Re: Alot of 1g Parts
 

yes i do

Re: Alot of 1g Parts
 

how much for the evo 8 fuel pump

Re: Alot of 1g Parts
 

75 would be a good deal on the fuel pump