MitsuStyle

MitsuStyle (http://www.mitsustyle.com/forums/index.php)
-   Mitsu vehicle parts for sale (http://www.mitsustyle.com/forums/forumdisplay.php?f=78)
-   -   FS: DIY - DSM SMIM Parts (http://www.mitsustyle.com/forums/showthread.php?t=35710)

Halon 09-29-2016 04:28 PM

FS: DIY - DSM SMIM Parts
 
5 Attachment(s)
I still have my parts from a long time back when I was going to make my own intake manifold for my Talon. I don't even own a DSM anymore so no use for it, lol.

- 4" x 4" x 1/8" wall (16" long) - Square extruded Aluminum to act as plenum

- 4" x 1/2" thick (16" long) - Aluminum plate to act as the bottom of the plenum for radiused holes

- (2) 4" x 4 x 1/2" thick - Aluminum plates to go on the ends of the plenum (one of which you would drill/cut to be TB flange)

- 3/8" thick aluminum Intake Manifold Head flange (I believe these were for 1G sized ports).


Only thing you still need is some 2 1/4" piping for the runners.

I was basically going to mimic this guys setup
http://www.dsmtuners.com/threads/bui...nifold.273139/


$55 shipped

$35 if you come pick it up.


http://mitsustyle.com/forums/attachm...1&d=1475184490

http://mitsustyle.com/forums/attachm...1&d=1475184490

http://mitsustyle.com/forums/attachm...1&d=1475184490

http://mitsustyle.com/forums/attachm...1&d=1475184490

http://mitsustyle.com/forums/attachm...1&d=1475184490


All times are GMT -5. The time now is 08:26 AM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.