Need help!!!!!!!!!!!!
OK I put a new head gasket in my evo 03 and when I went for a test run I saw that I was hitting 23lbs of boost and I was told buy the guy I got if for that it was set at 18lbs so I lower the boost and now I CAN"T REV OVER 4500RPM and it is making about 9 to 11lbs of boost. I have a switch for my AEM one setting is for 93 at 18lbs and the other is for 110 at 23lbs. I for got that I had this switch before I lowed the boost. I tried to raise the boost but nothing happen. So I really need help on this one.
|
Re: Need help!!!!!!!!!!!!
Get your car retuned by Shane @ DB. There is no reason to only be running 18psi on 93 octane. I'm running 25psi on BP 93 Ultimate with the stock Evo IX turbo.
|
Re: Need help!!!!!!!!!!!!
Take it to shane and get it tuned/troubleshooted before it blows up again. Seriously, do NOT fuk around!
Where did this car come from anyways? 2.3/35R sounds like fun! Share pics/info! |
Re: Need help!!!!!!!!!!!!
Quote:
EAGLE 2.3 STROKER W/ WIESCO PISTONS & EAGLE RODS EAGLE CRANK. ARP HARDWARE THROUGHOUT THE WHOLE ENGINE BUSHUR TOP MOUNT GT35R RNR FULL EXHUAST SYSTEM SPEARCO FRONT MOUT INTERCOOLER WITH 2.5" INTERCOOLERPIPING.. DLI IGNITION & C.O.P SETUP AFTERMARKET INTAKE MANIFOLD W/ 70mm ACUFAB THROTTLE BODY.. CROWER VALVE SPRINGS AND REATIANERS 3 ANGLE VALVE JOB 1MM O/S SS VALVES AEM ENGINE MANAGEMENT EXEDY PRESSURE PLAT W/ CLUTCH NET 4-PUCK CLUTCH ADJUSTABLE VENOM CAM GEARS SHIFTGLOW BOOST/ A/F & OIL PRESURE GAUGES TEIN LOWERING SPRING'S TIAL BOV & WASTEGATE SMALL STINGER BATTERY HKS 280 CAMS TOYO RADITATOR http://i259.photobucket.com/albums/h...e/IMG_0056.jpg http://i259.photobucket.com/albums/h...e/IMG_0062.jpg http://i259.photobucket.com/albums/h.../IMG_0014e.jpg |
Re: Need help!!!!!!!!!!!!
And in the meantime DO NOT BEAT ON IT!!
|
Re: Need help!!!!!!!!!!!!
You never answered Scheides question, haha.
|
Re: Need help!!!!!!!!!!!!
Geez, you had to replace your head gasket too. You make 3 of us with evo's replacing head gaskets in the past week.
|
Re: Need help!!!!!!!!!!!!
Mike, you had to replace your head gasket?
|
Re: Need help!!!!!!!!!!!!
Quote:
|
Re: Need help!!!!!!!!!!!!
Quote:
|
Re: Need help!!!!!!!!!!!!
I think I may have found out why I can't make any boost. I was looking on some other forum and I read that other people were having the same thing happen to them and It's a boost leak or a bad wastegate. I had this happen the first time when I got the car when it wouldn't let me rev over 4500RPM in neutral. So I was thinking it was a launch control set up for the AEM. I have a way to test the wastegate to see if it's bad. It make sent because the wastegate is what make the boost right and by using a boost controller you are controlling the amount of boost that the wastegate makes. I have tryed to raise mine back to 23lbs and know matter how much I raise the boost up it wont make over 10lbs.
|
Re: Need help!!!!!!!!!!!!
Quote:
|
Re: Need help!!!!!!!!!!!!
Quote:
|
Re: Need help!!!!!!!!!!!!
So you're trying to get it to make boost again without having any idea what's going on in the engine? I would suggest you stop now and let someone who knows what they're doing fix it. If you continue on this path too much longer, it could end up getting very expensive for you.
|
Re: Need help!!!!!!!!!!!!
Ya its just a lot of a turbo car to start out with. Just to start off you need a boost leak tester, compression tester, and dear god you need a laptop for that car before you even buy the car. trying to help
|
Re: Need help!!!!!!!!!!!!
Quote:
|
Re: Need help!!!!!!!!!!!!
Have you compression and leakdown tested it to make sure your headgasket swap was successful?
|
Re: Need help!!!!!!!!!!!!
I know what is was & fixed it
|
Re: Need help!!!!!!!!!!!!
Quote:
|
All times are GMT -5. The time now is 10:45 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.