polishing vibrator
 

You can polish parts a lot quicker and professionally! It is out of thick metal, a little bit of surface rust is pretty much nothing, with a can of paint you can make it look brand new. I will most likely end up doing that myself before its sold.

It was used by a local shop until it closed. It has a new motor in it, and comes with 180 Pounds
of stripping/polishing media, that alone is worth over $800

Dimensions:
29" x 18.5" x 19.5"
corner to corner you can fit in a part thats 34" long!!


The bad:
the lining around the drain started pealing a bit away but i will fix that before it is sold.



$700 gets you everything.

http://enesg.com/gallery/d/8034-1/Side1.jpg
http://enesg.com/gallery/d/8022-1/top5.JPG

More Pics here


-Enes

Re: polishing vibrator
 

This thread is no where near as naughty as i thought it was be from reading the title :p GL with the sale e-man!

Re: polishing vibrator
 

its pretty big, hell you could make a pleasure adapter if you want! .. get 2 things accomplished at the same time!!!

Re: polishing vibrator
 

It doesn't damage aluminum parts?

Re: polishing vibrator
 

Depends what media you use.. there are dozens of other media out there that you can load the thing with ... and since it has rubber lining i don't think it will damage any part. But as i said, depends what media you use.

The media i have is for rough surfaces first. you would just need to get some finer media which is A LOT cheaper.
Plenty out there

polishing media on ebay