WTF happened?
 

well i got my car back from primo the otherday with the trasfercase seal and yoke/ujoint replaced, and my new exhaust i love it only issue is while driving to work today i went to accel thur the intersection and nothing happend..

It was in gear, and clutch pedal all the way out but nothing happend. I looked at all the easy stuff, slave cyl, master cyl, they both work fine, shifter cables the move fine, it goes into gear but when you let out the clutch nothing happens it has a brand new clutch and there is no burning clutch smell at all.

I feel like its something inside of the tranny its self, but that would lead me to think i would atleast have one gear that works but none do, idk how thes trannys work on the inside so idk let me know what you think it is
thanks,
Ryan

Re: WTF happened?
 

So does the car rev like it's in neutral? Please explain "nothing happens".

Re: WTF happened?
 

yes it just free revs like its in neutral

Re: WTF happened?
 

yes i can start the car in gear i can shift into "gear" without pushing the clutch in

Re: WTF happened?
 

Can you shift it when its running with out pushing the clutch in? How does your pedal feel? You sure your fork is moving?

Re: WTF happened?
 

possible, i think i would have hurd this though there are no strange noises at all.. ill see if i cant take off that plat on the bottom of the tranny and look into the bellhousing to see if i can see anything

Re: WTF happened?
 

yes i can
like it always has
100% positive

Re: WTF happened?
 

Maybe it pumped up and isn't allowing the clutch to engage. Try adjusting your pedal to grab lower, towards the firewall.

Re: WTF happened?
 

tried pumping it, but its as if there is no clutch i think the pressure plate bolts backed out the peadle it adjusted to grab as low as possible

Re: WTF happened?
 

No, I meant sometimes after a clutch install the pedal grab point can creep up to the top, but if you've adjusted it as low as it can go then nevermind. Time to take off the transmission.

Re: WTF happened?
 

Remove the tranny, and the problem should become much more apparent.

Re: WTF happened?
 

Have you checked your shifter cables at the tranny?

Did they disconnect something?

Re: WTF happened?
 

primo is coming to get it tomorrow, if its install related they will warrenty i will let you know what the find is

Re: WTF happened?
 

yup just checked them they are connected

Re: WTF happened?
 

Did you make sure they're moving at the tranny, too?

Re: WTF happened?
 

yes i did

Re: WTF happened?
 

Sounds like a clutch disc failure.

Re: WTF happened?
 

yes it does but you would thik i would have smelled some clutch

Re: WTF happened?
 

Does it make any kind of rattling noises? I would think if it was a disc failure or some other kind of mechanical issue it would be making all kinds of noise. Sounds to me like maybe the piston in your slave jammed at full extension?

Re: WTF happened?
 

no noises at all, no clutch smell pedal feels fine... slaves rod moves with no issues, primo has the car atm and they are looking at it, we will see lol im fudging boggled on what the heck it could be..

me and mike thought maybe a cracked clutch hub but idk that would make lots of noise.. we will see i guess

Re: WTF happened?
 

Brought the car in to figure out what was wrongs. Put it on the hoist and checked to make sure everything was moving correctly through the clutch fork hole, Slave moved fine, TOB moved fine, Pressure plate moved fine. After bumping the started a few times to gain access to the PP bolt it started making a noise. Started the car and it made a noise after shutting the car off. Like the clutch disc was bouncing/spinning around in there.

Re: WTF happened?
 

so now the question is whats a good clutch disk under 200$ that is streetable that wont pop springs(looking at unsprungs mostly) lol all i need is the disk not a kit.. this is a e316g car and will be on e85 around 350 at db im hoping

Just ordered my clutch disk went with an act unsprung street disk i didnt even know they made them lol

Re: WTF happened?
 

I used a clutchnet disc (sprung 6-puck) with an ACT PP.

Re: WTF happened?
 

i was trying to stay away form the sprung disks otherwise i was looking at a act sprung 6puck

Re: WTF happened?
 

K. Good luck with whatever you choose. I always ran a sprung disc.

Re: WTF happened?
 

I run a sprung disc as well. Much easier if it's a street car.

Re: WTF happened?
 

Primo ever figure out your problem? I'm having the same thing kinda when cars off goes in gear when on it gets stuck between neutral an any gear! So sick of replacing parts an pulling that fat ass tranny off. New slave, fork, ball, clutch/p.p/flywheel (tryed two different set ups) bled it like stuck pig, fiddled with pedal adjusment?? Stumped?

Re: WTF happened?
 

it ended up being a broken clutch disk, and i ordered an act unsprung street disk to rplace it

Re: WTF happened?
 

im still waiting for my clutch to show up from act.. its been a week now...

Re: WTF happened?
 

im sick and tired of waiting on act for my fucking clutch im gonna look at the clutch net disk like halon sugested and maybe ill order one up

Re: WTF happened?
 

:stooges:

A real bugger. Why is it taking so long anyway? Did they say anything? You may be better off with another.

Re: WTF happened?
 

they didnt have any reasons, so i ordered a 6puck sprung disk from clutchnet they look high qualitly and hopefully ill have it by tuesday, when i get my act clutch(if it ever shows up) i'll send it back for a refund...

Re: WTF happened?
 

well my clutch from clutchnet got here withing 2days of ordering it i dropped it off at primo tonight so idk im hoping to have my car by tuesday =/ we'll see

Re: WTF happened?
 

Stopped by map and picked up a depo wideband o2 kit, it looks really nice I also ordered a gauge bezle for the hvac vents. I plan on moving my boost gauge there and also putting my new wbo2 there too, I also ordered some projector h3 4x6 headlights to replace my foggy dim stock h3666 headlights. it came with and hid h/l h3 bulbs only issues is they are 10000k I would have prefered something more like 6000k but it will be fine for now.. I'll post pics when it's all in and installed, I was also gonna add some sound clips and pics of the exhaust I had primo do for me.. It turned out great I couldn't be happier with it, it's VERY VERY loud so I picked up a silencer and it helps a lot it got rid of all the drone I had from the 3.5 muffler pics and updates to come when I get my car back!!