Parting Out 2G
 

Parting out a 1995 Eclipse GSX
Car has about 160000 miles on it. Dark green exterior with grey leather interior with sunroof. Exterior is a 6 out of 10(only because of the passager fender and hood) and the interior is a 6 out of 10. Engine bay is painted flat black. Passanger fender is off the car and needs paintWas going to do a 6bolt swap but the funds have run out. (VIN upon request)

Aftermarket parts I have...
97-99 Projector headlights(brand new)
SS auto chrome short route FMIC(brand new)
97-99 Front bumper(brand new)
Bomz racing intake(used)
Prothane motor mounts(New,Installed)
Triple A Pillar(used)

6Bolt parts...
Brand new(OEM) timing belt and timing belt components. New water pump and clutch(non OEM). and the whole 6bolt longblock. Everything you need to get the car up and going minus an alternator and misc bolts.

If anyone is interested in everything(car and aftermarket parts) that would work out better.

Re: Parting Out 2G
 

Does the motor run? Any mods made to it for 2g fitments?
Also, the 2g maf? How much?

Re: Parting Out 2G
 

I never ran the motor, It was just put together.

Re: Parting Out 2G
 

I'd probably take those headlights if the price was right. What are you looking to get? I'll trade you my stockers plus cash if youd like.

Re: Parting Out 2G
 

Where did you get the motor and what was done to it?

Re: Parting Out 2G
 

How much for all or just the shell?

Re: Parting Out 2G
 

Do you still have the original Eclipse floor mats? Condition?

Re: Parting Out 2G
 

What clutch do you have?

Re: Parting Out 2G
 

is motor ready for a 2g drop in??? pm me if it is!!!

Re: Parting Out 2G
 

Whats the size of FMIC and plumming, and are you willing to seperate?

Re: Parting Out 2G
 

I’m interested in the center counsel and AC controls and trim let me know how much you want. Pics would be great too. Thanks

Re: Parting Out 2G
 

a few questions, would a greddy type S fit on the ic piping, and do u have ne pics of the intercooler on the car.

Re: Parting Out 2G
 

bump, i know this guy, he is a good guy

Re: Parting Out 2G
 

The type s would bolt right on to the ic piping. I never put the intercooler on the car.

Re: Parting Out 2G
 

The clutch is brand new, its just a stock one.

Re: Parting Out 2G
 

I dont have the floor mats for the car.

Re: Parting Out 2G
 

BUMP! AWD stuff spoken for ;)

Re: Parting Out 2G
 

Whats the size of FMIC and plumming, and are you willing to seperate?

Re: Parting Out 2G
 

I want to sell the front mount and piping as a kit.

Re: Parting Out 2G
 

I think the piping is 2.5 inch.

Re: Parting Out 2G
 

I also have a 95 eprom ecu.

Re: Parting Out 2G
 

hey i cna meet you and pay 225 tomorrow for ic and piping which is a good deal considering they go for 250 shipped.

Re: Parting Out 2G
 

Also on a side not im 99 percent sure a type s wil not fit the ic piping without drilling and tapping new holes closer together. They are set up with a 1g flange.

Re: Parting Out 2G
 

Mike, I'm interested in the longblock. You're PMs are full. Let me know how much you want for it.

Re: Parting Out 2G
 

His PMs SUCK! he can only get like 25 PMs.
You guys can PM me also, I am helping him part this car out.

Re: Parting Out 2G
 

eprom-sold
fmic-sold
2gmaf-sold

Re: Parting Out 2G
 

how are the 3 interior pannels in the hatch/trunk?

Do you still have the drive shaft?

Re: Parting Out 2G
 

Tranny, Tcase, Driveshaft, Rear End, Gas Tank, Rear Subframe, Rear Axles, Ebrake Cables, Starter, Front CV Shafts... SOLD

Re: Parting Out 2G
 

Do you have the center console, AC controls, and trim around the AC controls?

Re: Parting Out 2G
 

$80
Based on a completed Item on ebay(http://cgi.ebay.com/ebaymotors/MISUB...spagenameZWDVW)

Re: Parting Out 2G
 

How much for the 2g headlights, front bumper 2gb, and the motor mounts with the inserts? PM me with a price if you could.

Re: Parting Out 2G
 

I Want to make something clear:
I am acting as a middle man. I have admins OK to do so. I have no parts for sale Im just speaking for Mike S as he does not have access to a computer as often so Im here to make things faster and smoother. You can contact me or him but he is the one selling the items not me.

Mike B

Re: Parting Out 2G
 

Are you looking for the ACTUAL motor mounts with the prothane insersts or just the prothanes? Also he only has 2GB projectos and a primered 2GB front bumper. Let us know if thats what you are looking for and we will shoot you a price.

Re: Parting Out 2G
 

Do you have any pics of the projectors on the car? I'm really interested but I just can't decided. Thanks

Re: Parting Out 2G
 

Headlights...$100
Bumper...$75
Motor mounts w/ prothanes...$100

98GSX...
The headlights were never installed on the car. There is a pic on the first page of the headlights also Here is a pic on someone elses car.
http://www.team-2g.com/mitsubishi-ec...ad.php?t=18322


bob123131:
Your PMs are full. The FMIC is gone.

Re: Parting Out 2G
 

The awd stuff is coming off tomorrow, that stuff is sold, anyone need wiring harness,and interior stuff, I need the body gone by this weekend.

Re: Parting Out 2G
 

how are the interior pannels in the hatch area? Do you still have the upper portion of the left rear seat?

Re: Parting Out 2G
 

I still have almost all interior parts.

Re: Parting Out 2G
 

How about the stock radio side brackets?

Re: Parting Out 2G
 

I'll take all the plastic interior pannels from the rear and the left rear seat back. How much do yu want for them?

Also do you still have the drivers seat? If so how much for it?