Re: Project AutoX domination!
 

Is it done yet?!?

Re: Project AutoX domination!
 

Not quite, but should be close! I JUST ordered another pair of turbos. Managed to find them both for $160 shipped!!! I looked in a place I wasn't expecting to find cheap ones, and found cheap ones!

Re: Project AutoX domination!
 

That my friend is fricken sweet.

Re: Project AutoX domination!
 

I'd say only marginally sweet.

Re: Project AutoX domination!
 

+1. Wish I didn't have to swap them again but at least they are cheap little fuckers. Too bad I got jacked in the first place.

Re: Project AutoX domination!
 

Lets sell all our cars and get cool bicycles.

Re: Project AutoX domination!
 

+1. Bicycles are so much cheaper, and easier to work on.

Re: Project AutoX domination!
 

FMIC on, pipes still off since I took my turbo's off today. New turbo's showed up, MaxQ GPS datalogger showed up. Most of the big work should be done this weekend. Rear set belts removed. Updated to 95+ non active exhuast, and Non ECS. (AKA took 3 lbs out of the trunk)

Re: Project AutoX domination!
 

Post the fmic pics here you douche! I saw them in photopost, it looks a little goofy with the two little pipes coming into one side and one big one out the other, but looks like a decent setup!

Re: Project AutoX domination!
 

I was going to but got destracted. As far as I know, mine might be the only 3S with pipes run like this.

http://www.mitsustyle.com/photopost/...m/PICT2074.JPG
http://www.mitsustyle.com/photopost/...m/PICT2078.JPG
http://www.mitsustyle.com/photopost/...m/PICT2082.JPG
http://www.mitsustyle.com/photopost/...m/PICT2085.JPG

Re: Project AutoX domination!
 

Aluminium pipes? If so, that's awesome.

Re: Project AutoX domination!
 

Yup, light weight. Going by feel, they are lighter than stock pipes. To bad the IC is as heavy as it is.

Re: Project AutoX domination!
 

What FMIC is this? Or did you do it custom?

How about a shot with the bumper on :) I like the bumper support bar as well, very nice :D

Re: Project AutoX domination!
 

It's kustom. The crash bar would have been left off, except for AX rules. I haven't taken any pics with the bumper on, but I haven't cut the hell out of the bumper. Just trimmed a little from the inside so it clear the IC.

Re: Project AutoX domination!
 

Looks great!

Re: Project AutoX domination!
 

The goal was as low of volume as possible and the least amount of bends. I think it turned out nice. Now you just need a tune and go Autox it up.

~John

Re: Project AutoX domination!
 

Wow, that FMIC is pretty big! I like the setup!

Re: Project AutoX domination!
 

24 x 12 x 4.5 It should do the trick.

Re: Project AutoX domination!
 

Is that an aluminum crash bar?

Re: Project AutoX domination!
 

Yup, stock. 94+ 3S's have an aluminum rear as well. I need to update to that.