|
Re: FP RED for evo 8 & 9
No. If you want to really push the limits with this turbo, you'll need to build the bottom end.
|
Re: FP RED for evo 8 & 9
still really impressive! ugh...i just want an Evo now. Someday.
|
Re: FP RED for evo 8 & 9
http://forums.evolutionm.net/6325638-post4.html
2005 Evo RS TBE no cat Comp 280/280 cams with stock gears RC 1200cc Walboro AEM intake AGP FMIC GM 3 port with ecu-controlled boost FPred (steveoSpec porting) Titek tubular 02 housing SteveoSpec ported exhaust manifold Forge WGA Upper/lower IC hardpipes Wilson/Indy Cali-spec intake manifold Stock long block Stock ECU Car weighs 2700lbs Road racing tune 110oct 30psi across http://www.norcalmotorsports.org/use...wer_101908.jpg ............................. 2006 Evo SE COBB 3" TBE MilSpec 100 cell cat Cosworth 280/272 M3 mivec cams HKS exhaust adjustable gear RC 1200cc Walboro ARC intake box 3.5" ETS FMIC GM 3 port with ecu-controlled boost FPred (steveoSpec porting) Titek tubular 02 housing Forge WGA Nisei Upper/lower IC hardpipes Wilson/Indy Cali-spec intake manifold Stock long block Stock ECU Road racing tune 100oct @ 27psi: http://www.norcalmotorsports.org/use...oct_102208.jpg I am seriously torn, this or the BBK....I'm still leaning this way, I think. It edges out the BBK up top. Both need more E85 numbers.... |
Re: FP RED for evo 8 & 9
Hands-down BBK.
|
Re: FP RED for evo 8 & 9
BBK cuz it has the blingin blue compressor wheel. hahaha
|
Re: FP RED for evo 8 & 9
That looks like an awesome bolton turbo.
|
Re: FP RED for evo 8 & 9
I'm pretty sure I'm NOT getting one of these now, just because a 2 month wait time is typical. But man, they sure do make pretty sweet power:
E-85 Fuel Buschur 2.0L Motor Buschur Stage 3 Head Cosworth M3 Cams Driven Innovations Intake Manifold Buschur Ported Exhaust Manifold Buschur Race FMIC Sparktech COP Ignition FP Red Turbo EPM 02 Dump Shep Trans and Tcase AEM Tuning By: Crispeed Built by: AWD Motosports http://i383.photobucket.com/albums/o...ians631red.jpg http://www.youtube.com/watch?v=U71Hxf0lDnk&hd=1 |
Re: FP RED for evo 8 & 9
I want a red so bad, seems like they keep making more and more power. If I didnt already have the 40R, I would have one of these now.
|
Re: FP RED for evo 8 & 9
Look at this car, very 'typical' car, not your standard balls-to-the-walls build.
2006 EVO9 BR 3" turbo back custom i/c pipes manual boost controller (not sure of brand, never seen one before) Stock 2 liter Stock head GSC cams FP red SS 02 housing Ported exhaust manifold K&N filter kit Walbro fuel pump SMC alky kit FIC 850 injectors AEM EMS, 3.5 bar map sensor, air temp sensor No wide band ETS 3" FMIC The car came out good, he was also running Valero "93" octane gasoline which is the worst fuel you can buy in the country. The car was tuned at 29 psi of boost. It was in the mid 20's here today and I use no correction on the dyno. 438 whp and 372 ft lbs of torque http://img.photobucket.com/albums/v2...stockMOTOR.jpg http://forums.evolutionm.net/evo-dyn...-meth-red.html |
Re: FP RED for evo 8 & 9
If he used weather correction, then the numbers would be lower.
|
Re: FP RED for evo 8 & 9
Bump, there's at least 2 locals with this turbo now making ~425-430whp on shane's dyno w/ E85, they need to post up ;)
|
Re: FP RED for evo 8 & 9
|
Re: FP RED for evo 8 & 9
Good numbers!
Does the boost taper off like that with most of the aftermarket stock frame turbos? |
Re: FP RED for evo 8 & 9
On high boost, yes. Some are better than others at pump gas levels. The green/red still taper a bit, but the BBK can be set to hold pretty flat (with ecu controlled boost). Either way, most don't taper nearly as bad as the stock turbo does. IX's are the worst.
|
Re: FP RED for evo 8 & 9
IX turbos aren't that bad with a proper setup. I set my MBC to peak at 25 and it tapers down to 21 at ~7500 RPM.
|
Re: FP RED for evo 8 & 9
The IX head/Mivec breathes better than the VIIIs. A IX turbo doesn't taper nearly as bad on an VIII compared to a IX.
|
Re: FP RED for evo 8 & 9
Quote:
|
Re: FP RED for evo 8 & 9
dont mean to get too OT with this question, but what would be the DSM equivalent of this turbo.
Unless I can cut some major spool of this HX35 i am looking at 3052s or GT3076s to be HTA'd down the road. How much boost is that on the dyno graphs? |
Re: FP RED for evo 8 & 9
Quote:
|
Re: FP RED for evo 8 & 9
The FP RED uses the same comp wheel as the HTA3076 (except reverse scroll). That's the closest thing out there.
I think I already said this earlier in this thread: http://www.mitsustyle.com/forums/sho...6&postcount=28 |
| All times are GMT -5. The time now is 08:45 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.