Re: Powder results
 

Well I suppose I might as well steal this pic off their site. But here's another VC I did for a local ;)

http://www.maperformance.com/gallery...enginebay3.jpg

Re: Powder results
 

Galants VC cleaned and ready for powder.
http://www.dsmstyle.com/photopost/da...ver_Before.JPG

Here it is fresh outta the oven
http://www.mitsustyle.com/photopost/...over_after.JPG

Here it is on the car. Sorry it's kinda dark outside
http://www.mitsustyle.com/photopost/...0377_small.JPG

Re: Powder results
 

Before:
http://www.mitsustyle.com/photopost/...edium/S362.JPG

After:
http://www.mitsustyle.com/photopost/...0356_small.JPG
http://www.mitsustyle.com/photopost/...0378_small.JPG

Re: Powder results
 

That turbo looks really good! Is that the "almost chrome" powder?

Re: Powder results
 

That's actually gunmetal with a clear coat. I guess it's hard to tell by the pics. Same color as my intercooler piping and intake that you see in a couple of the other pics. And yes, I did it to match my IC piping, because that turbo will be going into the Talon ;)

I haven't done a whole lot with that Chrome powder yet. just a couple little things. It seems to be really touchy.

Re: Powder results
 

sexy kinda!

Re: Powder results
 

Mark - here's a little preview of one of the others you gave me to do for you. Turned out better then that first one I'd say.

Re: Powder results
 

Might as well add my most recent VC.

Went for the OEM look with the red letters, and grey rest of it. Except instead of grey/silver, I did gunmetal to match all my piping and give it a slightly different then OEM look. Then put a coat of clear on it as well.

Re: Powder results
 

As soon as it's warm enough to use the bike for transportation again, I'll be bringing you mine. I have a black Hyundai cover that needs to be re-coated.

Re: Powder results
 

That cover looks great Brandon!

Re: Powder results
 

Sounds good man :)

Re: Powder results
 

Nice work! I think you just keep getting better at powdercoating.

Re: Powder results
 

Thanks thickums

Re: Powder results
 

Yes, very nice! How did you get the red on there?

Re: Powder results
 

I masked off most of the Valve cover with paper and sprayed down the red first in the areas where the lettering is. Then Cured it. Then took it out, let it cool off, and sprayed the entire cover with gunmetal. Then I slightly wet a sponge and used that to brush/absorb the gunmetal powder off the top of the letters. Then Cured. Took it out, let it cool, and covered the entire cover with a clear coat powder. Cured again. All done :) The gunmetal was a little bit light in some areas, so you can see a slight hue of red in some areas that the red was. I think it kind of looks neat personally!

Re: Powder results
 

^Nice, I need some work done too. Glad you didn't give up on this.

Re: Powder results
 

Ha, matter of fact I'm pretty sure I still have your strut bar :D