![]() |
Re: Evo X upgrades
Quote:
We *were* having suction line issues yesterday. I had taken this photo to ask you about it because it was not working like this: http://i959.photobucket.com/albums/a...uctionline.jpg |
Re: Evo X upgrades
Quote:
We tried quite a few things: running as a single pump, swapping fuel pump relays, the fpr from scheides' car, and checking electrical connections. When we unwrapped the wiring for connecting the pumps to the car, we discovered that the connections didn't look very sound and it didn't take much wiggling to break the ground wires off. We ended up jumpering the pump grounds over the car-side plug and once we did so, the fuel pressure stabilized. We still had lean conditions/misfires despite the good fuel pressure so we knew we had another problem. We siphoned 3 gallons of E85 from another car and dumped it into mine...turns out that the suction line on the Full Blown hanger was not getting fuel from the other side of the tank. It'd drain the side that the pump was on and run out of fuel. Full Blown gave me a suggestion for correcting the suction line (see the previous two posts) so I've done that. I've also hooked up the BlaqOPs secondary pump again. Hopefully we're good to go now. I'm planning to run a 5gal can of E85 up to DB today...too bad there isn't a station in Rogers. In the end we got one good pull in. As scheides mentioned, Shane pulled it around 6800 at 418hp since it ran out of single pump. My redline will be 9k when we're done so she has some more power to make. |
Re: Evo X upgrades
Quote:
Quote:
|
Re: Evo X upgrades
Mike, is the suction sitting inside the baffle or outside? It looks as though the hose that connects it to the housing it too long and the return may be bottoming out. If it is bottoming out, then it would block the return. Blocking the return will just pump the fuel into the otherside of the tank. When you reinstall it, make sure the pump assembly is not sitting on the line as well.
|
Re: Evo X upgrades
Here is how short we have it. Notice the siphon is sitting above the bottom of the pumps. The baffle should slide over all of this and protect it. Im glad you found the wiring issues. I knew it was something stupid. We never had an issue with the evo x and 2g kits. They are based on the same design.
http://i124.photobucket.com/albums/p...k/DSCN0056.jpg |
Re: Evo X upgrades
...I still smell like gas. Your car and scheides car I blame for this.
|
Re: Evo X upgrades
Quote:
Quote:
|
Re: Evo X upgrades
Thats awesome power, you will be the highest hp X once you are done in MN won't you?
it sounds like you are getting there man, keep up the good work. |
Re: Evo X upgrades
Quote:
|
Re: Evo X upgrades
I would like a ride when its done, after being in scheides X I can see why people like them so much, I think i need to drive one too.
|
Re: Evo X upgrades
Any update yet? Dyno numbers from today??
|
Re: Evo X upgrades
Quote:
For now:hide: |
Re: Evo X upgrades
Quote:
|
Re: Evo X upgrades
Quote:
|
Re: Evo X upgrades
Quote:
Hopefully you'll figure out the right wheel combo for me by then. :D |
Re: Evo X upgrades
Quote:
|
Re: Evo X upgrades
Quote:
http://media.ebaumsworld.com/picture...uchCharlie.png |
Re: Evo X upgrades
Quote:
I would like to have it sorted by the MAP weekend since my next HPDE is that Monday. Other than that it doesn't matter much. |
Re: Evo X upgrades
Quote:
|
Re: Evo X upgrades
Quote:
|
| All times are GMT -5. The time now is 03:35 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.